If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
kick zone question
Looking at a pair of nice classic skis for my daughter from a reputable shop
and the kick zone ends a couple inches in front of the heel. Ski is an Atomic RC11 (a ski which I have and am very happy with). Marked flex is correct for weight (according to mfg. guidelines). More importantly, "paper test" by competent tech. indicates a good fit for her weight and skiing ability in terms of 1/2 weight, full weight and weight on ball of foot. I think this is a decent fit for this ski. Length of kick zone is about the right length (forget what it is exactly, but it's not extremely short or anything like that). But I'm a little uncomfortable because the zone ends a full two inches in front of the heel of the boot. I've only had a couple of good quality striding skis, and it seems to me the paper test measured zone ends up right around the heel. I've adjusted kick zones with on snow testing and sometimes find it pays to decrease it a little in front of the heel, so that is a little comforting. Do you think this is strange, or just something to take into account when waxing? Cam |
Ads |
#2
|
|||
|
|||
On Fri, 25 Feb 2005, Camilo wrote:
Marked flex is correct for weight (according to mfg. guidelines). More importantly, "paper test" by competent tech. indicates a good fit for her weight and skiing ability in terms of 1/2 weight, full weight and weight on ball of foot. I think this is a decent fit for this ski. Length of kick zone is about the right length (forget what it is exactly, but it's not extremely short or anything like that). But I'm a little uncomfortable because the zone ends a full two inches in front of the heel of the boot. I've only had a couple of good quality striding skis, and it This is fine. Has happened for a couple of my skis as well. My local shop's experts (the guys at Finn Sisu) told me to take the measured zone as a guide, not as "written in stone". Wax the whole pocket (be bold, wax beyond the pocket) with a few layers of hard wax (on a hard wax day), and then go skiing for a fairly long time. Then look at the wax. If it's clearly warn off right below the heel, then the pocket for hard wax probably begins in front of the heel. Likewise for the front of the zone. -Ken ************************************************** ********* Kenneth Salzberg Hamline University School of Law (651) 523-2354 1536 Hewitt Ave. Sisu Skier - 50K Club St. Paul, MN 55104 ************************************************** **************** |
#3
|
|||
|
|||
Nothing unusual. I have two pairs like that. My 1996 RCS's are back at
the heel, but they were flexed at 75% of my weight (by Torbjorn's ex partner) and I only use them for lake races. If you ever see the Bjorn Daehlie video, his kick waxing starts well up into the foot. You/she don't need to be 'kicking' from the heel, but just in front of it (subtalar). Gene Camilo wrote: Looking at a pair of nice classic skis for my daughter from a reputable shop and the kick zone ends a couple inches in front of the heel. Ski is an Atomic RC11 (a ski which I have and am very happy with). Marked flex is correct for weight (according to mfg. guidelines). More importantly, "paper test" by competent tech. indicates a good fit for her weight and skiing ability in terms of 1/2 weight, full weight and weight on ball of foot. I think this is a decent fit for this ski. Length of kick zone is about the right length (forget what it is exactly, but it's not extremely short or anything like that). But I'm a little uncomfortable because the zone ends a full two inches in front of the heel of the boot. I've only had a couple of good quality striding skis, and it seems to me the paper test measured zone ends up right around the heel. I've adjusted kick zones with on snow testing and sometimes find it pays to decrease it a little in front of the heel, so that is a little comforting. Do you think this is strange, or just something to take into account when waxing? Cam |
#4
|
|||
|
|||
This is a intresting subject because i did some test last year on my own
skiis just because i had so damned bad grip and bad glide on my pairs. The good thing to work at a University is that you have acces to some wonderfull machines, i have a tensiletesting machine that can put a regulated force on whatever you chosse to put it on, choosed my skiis. I found out that one pair had a gripzone that diffed some 5 cm i total between the skiis and one pair was exact as it should. Both pairs had the wax pocket 0.1mm gap ending under the heel and the 0.3mm 3-4cm more foreward under the arc of the foot. The intresting thing with the skiis is that when putting the weight on the place of the heel then it took 75 kg to close the softer ski but putting the weight at the "balls" of the foot that is it only took only 40kg to close it. What does this means: if you lean backwards it makes the gripwax to rise over the surface and you GLIDE, if you put the weight forward you have grip to climb the threes. So start using the weight more to manipulate the glide/grip coffecients to yuor advantage instead of just walking on skiis. One reflection to this is if you have big feets and normal weight then move the bindings forward and vice versa. One more is that as you move the waxpocket more forward it is more difficult to "walk" on those skiis and have grip, you have to actively move your weight forward to get the skiis to close the waxpocket. So if you are novice on XC the wax backward and start walking on skiis, if you are professional i don't have to say that you wax forward and use your weight to tune the grip to your advantage. This tech thing is something for Roberts to dig into. Back to the original Atomic RC11 discussion, as a matter of fact i tested a pair of that type last week and they where wery uniform but the manufactor marking at the back was all screewed up, the pocked ended under the heel. The forward markings was nearly ok even a little bit further forward comparde to the markings. Gene Goldenfeld wrote: Nothing unusual. I have two pairs like that. My 1996 RCS's are back at the heel, but they were flexed at 75% of my weight (by Torbjorn's ex partner) and I only use them for lake races. If you ever see the Bjorn Daehlie video, his kick waxing starts well up into the foot. You/she don't need to be 'kicking' from the heel, but just in front of it (subtalar). Gene Camilo wrote: Looking at a pair of nice classic skis for my daughter from a reputable shop and the kick zone ends a couple inches in front of the heel. Ski is an Atomic RC11 (a ski which I have and am very happy with). Marked flex is correct for weight (according to mfg. guidelines). More importantly, "paper test" by competent tech. indicates a good fit for her weight and skiing ability in terms of 1/2 weight, full weight and weight on ball of foot. I think this is a decent fit for this ski. Length of kick zone is about the right length (forget what it is exactly, but it's not extremely short or anything like that). But I'm a little uncomfortable because the zone ends a full two inches in front of the heel of the boot. I've only had a couple of good quality striding skis, and it seems to me the paper test measured zone ends up right around the heel. I've adjusted kick zones with on snow testing and sometimes find it pays to decrease it a little in front of the heel, so that is a little comforting. Do you think this is strange, or just something to take into account when waxing? Cam |
#5
|
|||
|
|||
Thank you very much for the information guys. I thought as much, but
appreciate hearing from people who've BTDT. Cam |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Waxless skis kick zone degradation | Randy Bryan | Nordic Skiing | 3 | January 29th 05 10:30 AM |
waxing question: overlapping area between kick and glide zone | Mike Hui | Nordic Skiing | 4 | January 19th 04 01:40 AM |
Cool way to tell if your kick is right: Swing Step! | Jeff Potter | Nordic Skiing | 0 | January 8th 04 09:42 PM |
What I (think I) learned about kick waxing this weekend | Chris Cline | Nordic Skiing | 4 | December 18th 03 07:11 PM |
START kick scotch tape? | JMC | Nordic Skiing | 5 | December 17th 03 01:53 PM |