If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#14
|
|||
|
|||
Do you forget how to Ski?? Carvers
snip
S. Gione is right, take some skiing lessons to brush up your skiing skills. One more thing: skis have become better in the past years. I replaced my very old skis with carving skis - and it did make a great difference. Rent a pair of new skis, do some training for a day or two - and enjoy the rest of your stay. I don't think you forget how to ski, but remembering may take time depending on the equipment you are lumped with. My second week took 4 days to get to where I was on the last day of my first time on skis. I've always ended up with rented 185-190 non-carve planks, and the first day or so each time felt like a nightmare trying to turn them. By the Wednesday, there were definitely muscles I never knew I had!!! Last yr I got (newish) 175 carvers for the first time, and was back to normal by then end of the first warmup run. I've never been able to turn so easily, handle the bumps, and link so many turns. I don't know what it is, but in Lech I was advised I was not expert enough for carve skis for my 4th/5th week on snow, but in Les Gets they were dishing out carvers to newbies. snip It's not a puzzle. Carvers are designed to turn easily. All skis turn by a combination of being bendy and having a sidecut (ie narrower in the middle than at the ends. Your weight and centrifugal force bend the skis, so they attempt to follow the curve so created. The sidecut increases the bendyness and accentuates the curve. QED. However, all skis are a compromise. A carver ski will not be so stable in the straight line, and if you ski very fast or are very heavy for the length of ski the amount of turn created will be excessive and the skis will feel unpleasant as they try to 'overturn' inside the line you are setting. At speed, too, it can be difficult to 'ride' the carve in a long-radius turn if the ski is too soft. There is an additional problem with some skis (especially with French ones ?) that they lack torsional stiffness, and tend to twist out of the correct curved shape. This is accentuated in carvers by the sidecut. To test this, hold a ski upright in front of you with the tail held firmly between your feet. Try and twist the tip longitudinally. A good ski will twist very little, a bad ski will twist a lot. This is nothing to do with bendiness, which is a choice you make - more bendy for a slower skier, less bendy for a faster skier. Excessive twist means that the ski doesn't adopt the correct curved shape all along its length, but (usually the tip) twists out of line. In summary - the advice you were given in Lech was exactly wrong - newbies should ALWAYS have soft, short carvers, experts may prefer longer, stiffer, less sidecut skis depending on the sort of skiing they are planning. HTH. Jim Hutton |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dont`t forget | Martin | Snowboarding | 0 | October 8th 03 07:31 AM |