View Single Post
  #5  
Old March 1st 05, 12:40 PM
Mark
external usenet poster
 
Posts: n/a
Default

Terje Henriksen wrote:
"The Martins" skrev i melding
news:MZ_Jd.1380$u45.850@trnddc08...


The NNN2 binding and boot setup has the metal bar on the boot tucked
about 10mm back from the from of the boot sole, the NNN1 boot has the
bar right at the front edge of the sole. You can use NNN2 boots on a
NNN1 binding with a special rubber flexer installed but you can't use a
NNN1 boot in the NNN2 or NNN3 binding.



I do.


This interests me. I also have considered NNN boots onto new NNN2
bindings. Do you have any trouble with the heel being perched higher, or
have you "modded" it ? I mean by cutting two grooves (with a hot knife
or whatever) in the heel part of the boot ?

Ads